Installation and setup
BDA−N6−ALL−US−1.0www.noax.comPage 10 of 28
3 Installation and setup
3.1 Installation site
The Industrial PC is designed for challenging (harsh) environments.
However, please following the installation regulations:
F Avoid exposing the display to sun.
F Do not install the Industrial PC to be directly influenced by heat sources. Please see that there
is sufficient circulation of the rear panel, or rather, of the cool fins at the rear panel.
F Leave a minimum of 0.6 inch (15 mm) space to ensure sufficient air circulation.
í The device will switch off on its own if the temperature is out of the operating range.
F Do not mount the Industrial PC on heavily vibrating surfaces. If this cannot be avoided, attach
the device to shock and vibration absorbers.
F When the ProTouch is used on fork lifts or similar vehicles, it is imperative that you take addi-
tional measures to absorb shocks and reduce vibrations (available as an option: "Modifica-
tion for mobile use").
Special mounting brackets are available for mobile applications.
í You can find more information about installation and mounting brackets on our web
page www.noax.com
.
To Next Page
Loading...
