Copyright © 2008 Nokia. All rights reserved. 15
Get started
Get started
Install SIM card and battery
Always switch the device off and disconnect the charger
before removing the battery.
The SIM card and its contacts can easily be damaged by
scratches or bending, so be careful when handling,
inserting, or removing the card. Insert the SIM card with
the gold-coloured contact area facing down.
Charge the battery
Your battery has been precharged, but the charging levels
may vary.
1 Connect the charger to a
wall socket.
2 Connect the charger to
your phone.
3 When the battery is fully
charged, disconnect the
charger from the phone,
then from the wall outlet.
Switch the phone on and off
1 Press and hold the power key.
2 If the phone asks for a PIN code,
enter the code (for example,
displayed as ****), and select OK.
When you switch on your phone for
the first time, and the phone is in the
standby mode, you are asked to get
the configuration settings from your
service provider. Confirm or decline the query. See
"Configuration", p. 42, and "Configuration settings
service", p. 12.
Nokia_3610_APAC_UG_en.book Page 15 Monday, September 22, 2008 10:40 AM
To Next Page
Loading...
