22 Copyright © 2008 Nokia. All rights reserved.
Calls
1 In the standby mode, press and hold the volume key
down. A short tone sounds, and Speak now is
displayed.
2 Say the voice command clearly. If the voice recognition
was successful, a list with matches is shown. The phone
plays the voice command of the match on the top of
the list. If the result is not the correct one, scroll to
another entry.
Using voice commands to carry out a selected phone
function is similar to voice dialling. See Voice
commands in "My shortcuts", p. 37.
Call waiting
To answer the waiting call during an active call, select
Answer. The first call is put on hold. To end the active call,
press the end key. To switch back to the first call without
ending the second call, select Options > Swap.
To activate the Call waiting function, see "Call", p. 40.
Options during a call
Many of the options that you can use during a call are
network services. For availability, contact your service
provider.
During a call, select Options and from the following;
Mute, Unmute, Contacts, Menu, Lock keypad, Record,
Loudspeaker, or Handset.
Network services options are Answer or Reject, Hold or
Unhold, New call, Add to conference, End call, End all
calls, and the following:
Send DTMF — to send tone strings
Swap — to switch between the active call and the call on
hold
Transfer — to connect a call on hold to an active call and
disconnect yourself
Conference — to make a conference call of up to five
persons
Private call —to discuss privately in a conference call
Warning: Do not hold the device near your ear
when the loudspeaker is in use, because the
volume may be extremely loud.
Nokia_3610_APAC_UG_en.book Page 22 Monday, September 22, 2008 10:40 AM
To Next Page
Loading...
