Nokia 7705 - Support for BFD Failure Action with SR-TE Lsps

MPLS and RSVP-TE
110
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
[no] bfd-enable
[no] bfd-template
[no] wait-for-up-timer <seconds>
exit
When S-BFD is configured at the LSP level, separate S-BFD sessions with the same
configuration are enabled on all primary, secondary, and standby paths of the LSP.
Alternatively, S-BFD can be configured on the primary path or secondary path of the
LSP, as follows:
configure>router>mpls>lsp <name> sr-te
primary <name>
bfd
[no] bfd-enable
[no] bfd-template <name>
[no] wait-for-up-timer <seconds>
exit
configure>router>mpls>lsp <name> sr-te
secondary <name>
bfd
[no] bfd-enable
[no] bfd-template <name>
[no] wait-for-up-timer <seconds>
exit
standby
The wait-for-up-timer command only applies if the configured failure action is
failover-or-down. For more information, see Support for BFD Failure Action with
SR-TE LSPs.
3.12.6.2 Support for BFD Failure Action with SR-TE LSPs
S-BFD provides a mechanism to check the data path forwarding for an SR-TE LSP.
If an S-BFD session fails, the LSP can be brought operationally down when the
failure-action command is configured with the failover-or-down option. When the
failure-action command is not configured, an S-BFD failure will only raise a trap.
The failure-action command is available in the following context:
configure>router>mpls
lsp <name> sr-te
bfd
failure-action failover-or-down
no failure-action
The failure-action command is configured at the LSP level. It can be configured
whether S-BFD is applied at the LSP level or the individual path level. The failure-
action command can be configured even if the BFD template is not yet configured.