Nokia 7705 - Configuring MPLS Paths

MPLS and RSVP-TE
136
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
A:ALU-1>config>router>mpls# info
----------------------------------------------
interface "to-104"
admin-group "green"
admin-group "red"
admin-group "yellow"
label-map 35
swap 36 nexthop 10.10.10.91
no shutdown
srlg-group "SRLG_fiber_1"
exit
exit
no shutdown
3.20.4 Configuring MPLS Paths
When configuring an MPLS path for LSPs, the IP address of each hop that the LSP
should traverse on its way to the egress router must be specified. The intermediate
hops must be configured as either strict or loose, meaning that the LSP must take
either a direct path from the previous hop router to this router (strict) or can traverse
other routers (loose).
Use the following CLI syntax to configure a path:
CLI Syntax: config>router>mpls
path path-name
hop hop-index ip-address {strict|loose}
no shutdown
The following example displays a path configuration output.
A:ALU-1>config>router>mpls# info
------------------------------------------
interface "system"
exit
path "to-NYC"
hop 1 10.10.10.103 strict
hop 2 10.10.0.210 strict
hop 3 10.10.0.215 loose
exit
path "secondary-path"
hop 1 10.10.0.121 strict
hop 2 10.10.0.145 strict
hop 3 10.10.0.1 strict
no shutdown
exit
------------------------------------------
A:ALU-1>config>router>mpls#