Nokia 7705 - Configuration at Mirror Source Node; Configuration at Mirror Destination Node

Label Distribution Protocol
422
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
5.4.10.1 Configuration at mirror source node
Use the following rules and syntax to configure a spoke SDP at the mirror source
node.
• The sdp-id must match an SDP that uses an LDP IPv6 FEC.
• Configuring the egress-vc-label is optional.
CLI Syntax: no spoke-sdp sdp-id:vc-id
spoke-sdp sdp-id:vc-id [create] egress
vc-label egress-vc-label
5.4.10.2 Configuration at mirror destination node
Use the following rules and syntax to configure mirror service at the mirror
destination node.
• The far-end ip-address command is not supported with LDP IPv6 transport
tunnel. The user must reference a spoke SDP using an LDP IPv6 SDP coming
from mirror source node.
• In the spoke-sdp sdp-id:vc-id command, the vc-id should match that of the
spoke-sdp configured in the mirror-destination context at the mirror source
node.
• Configuring the ingress-vc-label is optional; both Static and T-LDP are
supported.
CLI Syntax: far-end ip-address [vc-id vc-id] [ing-svc-label ingress-
vc-label | tldp] [icb]
no far-end ip-address
spoke-sdp sdp-id:vc-id [create] ingress-vc-label
ingress-vc-label exit
no shutdown exit
exit
Mirroring is also supported with the PW redundancy feature when the endpoint spoke
SDP, including the ICB, is using an LDP IPv6 tunnel.