Nokia 7705 - PCEP Commands

PCEP
354
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
4.9.2.1 PCEP Commands
pcep
Syntax [no] pcep
Context config>router
Description This command enables the Path Computation Element Communication Protocol (PCEP) and
enters the context to configure PCEP parameters.
The no form of the command disables PCEP.
pcc
Syntax [no] pcc
Context config>router>pcep
Description This command enables the context to configure PCC parameters.
dead-timer
Syntax dead-timer seconds
no dead-timer
Context config>router>pcep>pcc
Description This command configures the PCEP session dead timer value, which is the amount of time
a PCEP speaker will wait after the receipt of the last PCEP message before declaring its peer
down.
The dead timer mechanism is asymmetric, meaning that each PCEP speaker can propose a
different dead timer value to its peer to use to detect session timeout.
The no form of the command returns the dead timer to the default value.
Default 120
Parameters seconds — the dead timer value, in seconds
Values 1 to 255