Nokia 7705 - 3.19 Basic MPLS Configuration

MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
131
3.19 Basic MPLS Configuration
This section provides information to configure MPLS and gives configuration
examples of common configuration tasks. To enable MPLS on a 7705 SAR router,
you must configure at least one MPLS interface. The MPLS interface is configured
in the config>router> mpls context. The other MPLS configuration parameters are
optional.
The following example displays an MPLS configuration output. The admin-group is
configured in the config>router>if-attribute context and associated with the MPLS
interface in the config>router>mpls>interface context.
A:ALU-1>config>router>if-attr# info
------------------------------------------
admin-group "green" 15
admin-group "yellow" 20
admin-group "red" 25
------------------------------------------
A:ALU-1>config>router>mpls# info
------------------------------------------
interface "system"
exit
interface "StaticLabelPop"
admin-group "green"
label-map 50
pop
no shutdown
exit
exit
interface "StaticLabelPop"
label-map 35
swap 36 nexthop 10.10.10.91
no shutdown
exit
exit
path "to-NYC"
hop 1 10.10.10.104 strict
no shutdown
exit
path "secondary-path"
no shutdown
exit
lsp "lsp-to-eastcoast"
to 10.10.10.104
from 10.10.10.103
fast-reroute one-to-one
exit
primary "to-NYC"
exit
secondary "secondary-path"
exit
no shutdown
exit