Nokia 7705 - Modifying RSVP-TE Message Pacing Parameters; Deleting an Interface from RSVP-TE

MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
147
3.22.2 Modifying RSVP-TE Message Pacing Parameters
RSVP-TE message pacing maintains a count of the messages that were dropped
because the output queue for the egress interface was full.
The following example displays a modified RSVP-TE message pacing configuration
output. Refer to Configuring RSVP-TE Message Pacing Parameters.
A:ALU-1>config>router>rsvp# info
----------------------------------------------
keep-multiplier 5
refresh-time 60
msg-pacing
period 200
max-burst 200
exit
interface "system"
exit
interface "to-104"
exit
no shutdown
----------------------------------------------
A:ALU-1>config>router>rsvp#
3.22.3 Deleting an Interface from RSVP-TE
Interfaces cannot be deleted directly from the RSVP-TE configuration. Because an
interface is created in the mpls context and then configured in the rsvp context, it
can only be deleted in the mpls context This removes the association from RSVP-TE.
Refer to Deleting an MPLS Interface.