Nokia 7705 - Page 185

MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
185
The no form of this command deletes the LSP template. The LSP template cannot be deleted
if a client application is using it.
Parameters template-name — specifies an LSP template name up to 32 characters in length. The
LSP template name and the LSP name cannot be the same.
mesh-p2p | one-hop-p2p — specifies the type of LSP the template signals
adaptive
Syntax [no] adaptive
Context config>router>mpls>lsp
config>router>mpls>lsp-template
Description This command enables the make-before-break (MBB) functionality for an LSP, LSP path, or
LSP instance created using an LSP template. When enabled for the LSP, a make-before-
break operation will be performed for the primary path and all the secondary paths of the LSP.
Default adaptive
adspec
Syntax [no] adspec
Context config>router>mpls>lsp
config>router>mpls>lsp-template
Description When enabled, the advertised data (ADSPEC) object will be included in RSVP-TE messages.
Default no adspec
bfd
Syntax bfd
Context config>router>mpls>lsp
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description This command enables the context to configure seamless BFD (S-BFD) parameters on an
LSP that is defined as an SR-TE LSP. The configuration in the config>router>mpls>lsp>
secondary context is valid only for SR-TE LSPs.