Get started
12
If the ignition sense wire is connected, turn off the car ignition. If you
turn off the ignition during a call, the car kit switches off after you end
the call.
■ First time use
When you switch on the car kit for the first time, you are asked to select
the desired language for the texts on the car kit display. Turn the Navi
wheel to scroll to the desired language, and press the Navi wheel to
select it.
After the language selection, you are asked to pair and connect the car
kit with a compatible mobile device using Bluetooth wireless
technology. See also steps 3 to 5 in “Pair and connect the car kit,” p. 12.
When your mobile device is connected to the car kit, you are prompted
to copy the contacts from the device to the car kit: turn the Navi wheel
to scroll to Yes, and press the Navi wheel to start the copying. If you
select No, you cannot use your saved contacts to make calls with the car
kit. To copy the contacts later, see “Contacts,” p. 18.
■ Pair and connect the car kit
Before using the car kit, you must associate (pair) and connect it with a
compatible mobile device that supports Bluetooth wireless technology.
When you use the mobile device with the car kit over a Bluetooth
connection, secure the device in the car using a compatible mobile
holder. However, you can maintain the Bluetooth connection in the car
even if you keep your device, for example, in a purse.
To charge the battery in your device while using the car kit, use a mobile
charger that is compatible with your device.
To pair and connect the car kit with a compatible device after the first
time use, do as follows:
1. Switch on the device and the car kit (see p. 11).
2. Press the Navi wheel in the standby mode, and select
Bluetooth > Pair with phone.
9200326_en1.fm Page 12 Thursday, January 25, 2007 11:09 AM
To Next Page
Loading...
