Installation
26
Do not mount the hands-free unit inside a metal housing or on a metal
surface because this will impair the Bluetooth connection between the
hands-free unit and the Bluetooth device that is connected to the car
kit. For an optimal connection, ensure that the distance between the
hands-free unit and a metal surface is over 4 mm (0.16 inch).
To mount the hands-free unit, use the hook and loop tape pads supplied
with the car kit in the same way as with the input device (see the figures
in “Input device CU-8,” p. 26). Detach the two pads from each other.
Attach the pad with the loops first: peel off the protective sheet from
the adhesive side, and attach the pad to the desired location in the car.
When you peel off the protective sheet, do not touch the adhesive side
with a finger. Ensure that the surface where you attach the pad is dry
and free from dirt and dust.
To attach the pad with the hooks, peel off the protective sheet from the
adhesive side, and attach the pad to the underside of the hands-free
unit.
Press the hands-free unit firmly onto the loop pad, and check that the
hands-free unit stays securely in place.
Input device CU-8
The input device should be located so that it is within easy reach of the
user. When installing the input device, ensure that it does not interfere
with or hinder the steering or braking systems or other controls or
systems used in the operation of the vehicle (for example, airbags).
Ensure that the input device cable reaches to the hands-free unit for
connection. The best location to mount the input device is horizontally
on the console between the driver’s and front passenger's seat so that
the input device keys are toward the front of the vehicle.
To mount the input device, use the hook and loop tape pads supplied
with the car kit. Detach the two pads from each other (1). Attach the
pad with the loops first: peel off the protective sheet from the adhesive
side (2), and attach the pad to the desired location in the car. When you
peel off the protective sheet, do not touch the adhesive side with a
9200326_en1.fm Page 26 Thursday, January 25, 2007 11:09 AM
To Next Page
Loading...
