FCC DRAFT
Vehicles
RF signals may affect improperly installed or inadequately
shielded electronic systems in motor vehicles such as
electronic fuel injection systems, electronic antiskid
(antilock) braking systems, electronic speed control
systems, and air bag systems. For more information,
check with the manufacturer, or its representative, of
your vehicle or any equipment that has been added.
Only qualified personnel should service the device, or
install the device in a vehicle. Faulty installation or service
may be dangerous and may invalidate any warranty that
may apply to the device. Check regularly that all wireless
device equipment in your vehicle is mounted and
operating properly. Do not store or carry flammable
liquids, gases, or explosive materials in the same
compartment as the device, its parts, or enhancements.
For vehicles equipped with an air bag, remember that air
bags inflate with great force. Do not place objects,
including installed or portable wireless equipment in the
area over the air bag or in the air bag deployment area.
If in-vehicle wireless equipment is improperly installed,
and the air bag inflates, serious injury could result.
Potentially explosive
environments
Switch off your device when in any area with a potentially
explosive atmosphere, and obey all signs and
instructions. Potentially explosive atmospheres include
areas where you would normally be advised to turn off
your vehicle engine. Sparks in such areas could cause an
explosion or fire resulting in bodily injury or even death.
Switch off the device at refueling points such as near gas
pumps at service stations. Observe restrictions on the use
of radio equipment in fuel depots, storage, and
distribution areas; chemical plants; or where blasting
operations are in progress. Areas with a potentially
explosive atmosphere are often, but not always, clearly
marked. They include below deck on boats, chemical
transfer or storage facilities, vehicles using liquefied
petroleum gas (such as propane or butane), and areas
where the air contains chemicals or particles such as
grain, dust, or metal powders.
Emergency calls
Important: Wireless phones, including this device,
operate using radio signals, wireless networks, landline
networks, and user-programmed functions. Because of
this, connections in all conditions cannot be guaranteed.
You should never rely solely on any wireless device for
essential communications like medical emergencies.
To make an emergency call:
1. If the device is not on, switch it on. Check for adequate
signal strength.
Some networks may require that a valid SIM card is
properly inserted in the device.
2. Press the end key as many times as needed to clear
the display and ready the device for calls.
3. Enter the official emergency number for your present
location. Emergency numbers vary by location.
4. Press the call key.
106
Additional safety information
file:///C:/USERS/MODEServer/mehowell/14385651/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 106 Jan 16, 2006 10:36:24 PMfile:///C:/USERS/MODEServer/mehowell/14385651/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 106 Jan 16, 2006 10:36:24 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
