Connecting devices
24
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02292-AAAA-TCZZA-02
The second Ethernet LAN/WAN connector is configured as LAN by default but can
be configured as Ethernet WAN by your service provider. If you have a fiber or cable
broadband access (Ethernet WAN) you can use it instead of a mobile radio
connection (wireless WAN). Contact your service provider who may offer either
wireless or wired connectivity.
You can connect the Ethernet WAN by connecting the Ethernet cable from your fiber
or cable router to the Ethernet WAN connector on the side of the FastMile 5G
Gateway 3.2.
Figure 11 Location of LAN/WAN ports on FastMile 5G Gateway 3.2
Connecting a device to the TEL port
If your device supports an optional TEL port, you can connect a land line device that
has a cable with an RJ11 connector to the TEL port on the backside of the FastMile
5G Gateway 3.2.
Note: When the Ethernet cable is connected to the Ethernet WAN connector port, the
FastMile 5G Gateway 3.2 will try to use it as a primary connection.
To Next Page
Loading...
