EasyManua.ls Logo

Nokia N96 - Certificate management

Nokia N96
189 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Automatic answer — Select whether you want the
device to answer an incoming call automatically
after 5 seconds. If the ringing type is set to Beep
once or Silent, automatic answer is disabled.
Lights — Set whether lights remain on or are
switched off after the time-out. This setting is not
available for all enhancements.
TV-out settings
To change the settings for a TV-out connection, select
TV-Out and from the following:
Default profile — Set the profile that you want
activated each time you connect a Nokia Video
Connectivity Cable to your device.
TV screen size — Select the aspect ratio of the TV:
Normal or Widescreen for widescreen TVs.
TV system — Select the analogue video signal
system that is compatible with your TV.
Flicker filter — To improve image quality on the
screen of your TV, select On. The flicker filter may
not diminish image flicker on all TV screens.
Security settings
Phone and SIM
Press , and select Tools > Settings > General >
Security > Phone and SIM card and from the
following:
PIN code request — When active, the code is
requested each time the device is switched on.
Deactivating the PIN code request may not be
allowed by some SIM cards.
PIN code, PIN2 code, and Lock code — You can
change the PIN code, PIN2 code, and lock code.
These codes can only include the numbers from 0
to 9.
If you forget the PIN or the PIN2 code, contact your
service provider. If you forget the lock code, contact
a Nokia Care point or your service provider.
See
"Access codes", p. 21.
Avoid using access codes similar to the emergency
numbers to prevent accidental dialling of the
emergency number.
Keypad autolock period — Select whether the
keypad is locked when your device has been idle for
a certain period of time.
Phone autolock period — To avoid unauthorised
use, you can set a time-out after which the device
automatically locks. A locked device cannot be used
until the correct lock code is entered. To turn off the
autolock period, select None.
Tip: To lock the device manually, press the
power key. A list of commands opens. Select
Lock phone.
© 2008 Nokia. All rights reserved.156

Table of Contents

Other manuals for Nokia N96

Related product manuals