Safety Precautions
Please read the following Safety Precautions before you start using the projector.
• Read all warnings and follow all instructions.
• Allow at least 20“ (50 cm) clearance around the projector to ensure proper ventilation.
• Place the projector in a well-ventilated area. Do not place anything on the projector that
prevents heat dissipation.
• Do not place the projector on an uneven or unstable surface. The projector may fall over,
causing personal injury or projector malfunction.
• Do not look straight at the projector lens during operation. The intense light beam may damage
your eyes.
• Do not block the projection lens with any objects when the projector is under operation as this
could cause objects to become heated and deformed or even cause a fire.
• Do not attempt to disassemble the projector. There are dangerous high voltages inside which
may cause death if you should come into contact with live parts.
• When moving the projector, be careful not to drop or bump the projector on anything.
• Do not place any heavy objects on the projector or connection cables.
• Do not stand the projector on end vertically. Doing so may cause the projector to fall over,
causing personal injury or projector malfunction.
• Avoid exposing the projector to direct sunlight or other sources of sustained heat. Do not install
near any heat sources such as radiators, heat registers, stoves, or other devices (including
amplifiers) that may increase the temperature of the projector to dangerous levels.
• Do not place liquids near or on the projector. Liquids spilled into the projector may cause it to
fail. If the projector does become wet, disconnect it from the power supply and contact us to
have the projector serviced.
• When the projector is under operation, you may sense some heated air and odor from its
ventilation grill. It is a normal operation and not a defect.
To Next Page
Loading...
