Norac UC4+ - Select the Sprayer Type

20
6.1.4 STEP 4: Turn On the UC4+ Control Panel.
If this is the first setup for the panel, this process will begin
automatically. If the panel was previously setup, you need to
select "Install?" from the SETUP menu to initiate
Automatic System Setup.
If other messages appear on the LCD screen during the following steps, refer
to Section 9.1 for more information.
6.1.5 STEP 5: Select the Sprayer Type
↓ ↓
⇒
↓Select
⇒
↓Type↓+/-
• Use the " +/- " switch to toggle through a list of available sprayer
types. The types are listed in Section 11 on page 54.
↓AN2 ?
• When the desired type is shown, confirm the selection with the
"AUTO (YES)" switch. Toggle "SETUP (NO)" to exit.
↓Dfalting
• The control panel is loading all the settings for your sprayer.