SERVICE MANUAL
11
www.norcold.com
CAUTION! The rear of the refrigerator has sharp edges and
corners. To prevent cuts or abrasions when working on the refrigerator,
be careful and wear cut resistant gloves.
Remove the Refrigerator
1. Remove the DC wiring from the battery or the converter of the
vehicle.
2. Put a mark on the DC wires so that you can put them back in
the correct location.
3. Remove the DC wires from the refrigerator.
4. Remove the screws which fasten the refrigerator to the fl oor.
5. Remove the door from the refrigerator.
6. Remove the screws which fasten the refrigerator to the wall.
7. Remove the refrigerator from the opening.
Replace the Refrigerator
1. Push the refrigerator completely into the enclosure.
2. Remove the door from the refrigerator.
3. Put the screws through the mounting fl ange and into the wall.
4. Attach the door to the refrigerator.
5. Open the lower intake vent and put the screws through the
refrigerator into the fl oor.
6. Connect the DC wiring to the battery or the converter.
7. Connect the DC wires from the refrigerator.
!
Remove / Replace the Refrigerator
To Next Page
Loading...
