Nord Drivesystems SK 510P Supplementary Manual

5 Parameters
BU 0630 en-2020 47
Pos: 27 9 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ Par ameter aufli stung (P000 .. .)/P5 00-P5 99/!Z usatz parame ter P 5xx [SK xxx E] @ 9\mod_1447148400288_388.docx @ 262070 @ 3 @ 1
5.2.2 Additional parameters
Pos: 28 0 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ Par ameter aufli stung (P000 .. .)/POS ICON/ Saf ety [Saf ety auß er SK 500 P]/P5 00 bis P5 99 (POS ICON/ safet y)/P 506 - Aut o Stör ungsquitt. ##### safety ##### @ 15\mod_1486122466618_388.docx @ 2318614 @ @ 1
P506 Automatic fault acknowledgement S
Description
Automatic acknowledgement of fault messages. (For details see

BU 0600)
Note
Automatic error acknowledgement should not be used in association with a safety
function.
Setting values
0
= Detection is disabled
Pos: 28 1 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ Par ameter aufli stung (P000 .. .)/P5 00-P599/P506 - Aut o. St öru ngs quit t._ Ein stel lw ert e [SK 50 0P] @ 4 4\mod_1594199499043_388.docx @ 2643777 @ @ 1
0
No automatic fault acknowledgement
When using the
control terminals to
control the FI, the
error message is
acknowledged by
removing the
enabling signal.
1
… 5
Number of permissible automatic fault
acknowledgements within one mains-on
cycle. After mains off and switch on again,
the full amount is available again.
6
Always, a fault message will always be
acknowledged automatically if the cause of
the error is no longer present, see note.
7
Quit disable, acknowledgement is only possible using the OK /
ENTER key or by switching off the mains. No acknowledgement is
implemented by removing the enable!
Pos: 28 6 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par amet er/ Par amet erau fli st ung (P 000 .. .)/P OS ICON/ S afety [S afety a ußer SK 500 P]/ P50 0 bi s P5 99 ( POS ICO N/ safet y) /P55 9 - DC-Nachlaufzeit ##### safety ##### @ 15\mod_1486124380702_388.docx @ 2318649 @ @ 1
P559 DC run-on time S P
Setting range
0,00 … 30,00 s
Factory setting
{ 0.5 }
Description
Completion of a braking action by temporary connection of a DC voltage to the motor
connection terminals.
(For details see BU 0600)
Pos: 28 8 /Anlei tu nge n/El ektr onik /P OSI CON /7. Stör ung sm eld ung en/!M el dung en zum Betr ie bszus ta nd @ 14\m od_1478870759752_388.docx @ 2303344 @ 1 @ 1

Nord Drivesystems SK 510P Specifications

General

Brand	Nord Drivesystems
Model	SK 510P
Category	DC Drives
Language	English