3 Options
BU 0600 en-2319 55
Assembly
Modules should not be inserted or removed unless the device is free of voltage. The slots may only
be used for the intended modules.
Installation of a technology unit separate from the frequency inverter is not possible.
connected directly to the frequency inverter.
Installation must be carried out as follows:
1. Switch off the mains voltage, observe the waiting period.
2. Push the control terminal cover down slightly or remove.
3. Remove the blank cover by activating the release mechanism at the lower edge and removing it
with an upwards rotating movement.
4. Hook the technology unit onto the upper edge and press in lightly until it engages. Take care that
the connector strip makes proper contact.
5. Close the control terminal cover again.
terminal cover
To Next Page
Loading...
