Supplementary Manual DeviceNet for NORDAC SK 200E
62 Subject to technical amendments BU 0280 GB
5.2.4 Module information parameters specific to the bus (P180)
Parameter
{Factory setting}
Setting value / Description / Note Device Supervisor
Parameter
set
P180 DeviceNet address:
0 ... 63
{ 0 }
Each module transmitting on the bus must be allocated a unique address. After the new setting
of addresses, all the devices on this bus must be restarted by switching the power supply off
and on again.
P181 DeviceNet baud rate
0 ... 2
{ 0 }
3 different baud rate settings are available:
0 = 125 kBaud
1 = 250 kBaud
2 = 500 kBaud
To Next Page
Loading...
