nord NORDAC SK 5xxE Series - Page 102

NORDAC SK 5xxE Manual
102 Subject to technical alterations BU 0500 GB
Parameter Set value / Description / Note Device Supervisor
Parameter
set
P481 ... - 01
...
... - 10
Function Bus I/O Out Bits
S
The Bus I/O Out Bits are perceived as multi-function relay outputs. They can be set to the same
functions (P434...443 / P624...629).
[01] = Bus I/O Out Bit 0
[02] = Bus I/O Out Bit 1
[03] = Bus I/O Out Bit 2
[04] = Bus I/O Out Bit 3
[05] = Bus I/O Out Bit 4
[06] = Bus I/O Out Bit 5
[07] = Flag 1
[08] = Flag 2
[09] = Bit 10 BUS status word
[10] = Bit 13 BUS status word
0 ... 38
[ 0 ]
The possible functions for the Bus Out Bits can be found in the table of functions for
the relay P434.
For further details, please refer to the manual for the AS interface, BU 0090.
P482 ... - 01
...
... - 08
Standardisation Bus I/O Out Bits
S
-400 … 400 %
[ 100 ]
Adjustment of the limit values of the relay functions/Bus Out Bits. For a negative value, the output
function will be output negative.
When the limit value is reached and the setting values are positive, the relay contact closes, with
negative setting values the relay contact opens.
P483 ... - 01
...
... - 08
Hysteresis Bus I/O Out Bits
S
1 … 100 %
[ 10 ]
Difference between switch-on and switch-off point to prevent oscillation of the output signal.