NordicTrack C2 Si - Page 7

7
3. While another person holds the Upright (6) near
t
he Frame (1), connect the Upper Wire Harness
(55) to the Lower Wire Harness (51). Next, pull
the excess Upper Wire Harness out of the top
of the Upright.
Tip: Avoid pinching the wires. Slide the
Upright (6) onto the Frame (1). Attach the
Upright with four M10 x 25mm Patch Screws
(46) and four M10 Split Washers (63). Tighten
the two Patch Screws in the front of the
Upright first, and then tighten the other
Patch Screws.
3
63
63
63
46
46
1
55
51
46
6
Avoid pinching
the wires
4
4. Identify the Right and Left Handlebars (35, 36),
which are marked with “Right” and “Left” stick-
ers.
Orient the two Handlebar Posts (7) and the
Right and Left Handlebars (35, 36) as shown.
Make sure that the Pulse Sensors (30) and
the hexagonal holes are in the indicated
locations.
Locate the Right and Left Pulse Wires (54, 67)
in the Right and Left Handlebars (35, 36). Then,
insert the Right and Left Pulse Wires through
the Handlebar Posts (7).
36
67
54
7
7
35
30
30
Hexagonal
Holes
Hexagonal
Holes