ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own Phillips screwdriver _, adjustable
wrench _::_:_, and rubber mallet :::z:zz:::z_.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre=
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
\
/
\
Wave Washer Large Wave M8 Washer M8 x 23mm M8 x 23mm
(80)-2 Washer (89)-4 (39)-4 Thin Washer Washer (31)-8
(96)-4
M4 x 16mm M4 x 16mm
M8 Split M10 Split Blunt Screw Round Head
Washer (97)-16 Washer (99)-4 (33)-6 Screw (92)-19
M8 x 19mm Patch
Screw (86)-6
M8 x 23mm Shoulder
Screw (45)-4
M8 x 14mm Patch
Screw (84)-6
M8 x 45mm Patch
Screw (90)-6
M10 x 80mm Button Screw (93)-4
5
To Next Page
Loading...
