NordicTrack E500 - Step 3: Swing Bar and Footplate Installation

8
STEP 3
I. Fasten footplate support bars (26R+L) from the crank with coated Allen bolts (16), spring washers (17), washers
(34) and tube spacer (35). Secure the plastic cover (38) onto footplate support bar with screw (39).
II. Slide the upper swing bar Left and Right (14) into the Center Shaft and secure using curved washers (100) two
coated Allen Bolts (16), two washers (18), two spring washer (17).
III. Fit the lower swing bar Left and Right (22) by slotting them into the upper swing bar Left and Right (14) and
loosely fit four Allen bolts (20) and four nut (21).
IV. Fasten footplate support bars (26 R+L) parallel (don’t incline) to the lower swing bars (22 R+L) and secure it
with Allen bolts (23),wave washers (24), washer (28), washer (27) and nuts (21). Then put the plastic cover (29)
onto footplate support bar left and right with screws.
V. Fit the upper swing bar and lower swing bar and secure it four Allen bolts (20) and four nut (21)tighten fully.
Then put the plastic cover (13) onto swing bar left and right with screws,Secure the plastic cover (6) with screws
(5).
13R
13L
22
29
27
39
38
34
35
23
24
16
17
18
96
14L
14R
5
6
28
20
21
21
16
17
100