32
HOW TO MAINTAIN THE EXERCISE BIKE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does not display accurate feedback, the
reed switch should be adjusted. Before you adjust the
reed switch, unplug the power cord.
Next, insert a standard screwdriver under the left
Shield Disc (18) in the location shown by the arrow,
and gently pry the Shield Disc off the Left Shield (11).
Then, carefully move the Shield Disc over the Left
Crank Arm (63) and away from the opening in the Left
Shield.
See the inset drawing at the left. Locate the Reed
Switch (35). Turn the Left Crank Arm (63) until a
Magnet (55) is aligned with the Reed Switch. Next,
loosen the M5 x 16mm Screw (76), slide the Reed
Switch slightly closer to or away from the Magnet, and
then retighten the Screw.
Then, plug in the power cord, and move the Left
Crank Arm (63) back and forth so that the Magnet (55)
passes the Reed Switch (35) repeatedly.
Repeat these actions until the console displays correct
feedback. Then, reattach the left shield disc.
MAINTENANCE AND TROUBLESHOOTING
55
35
63
76
18
63
11
To Next Page
Loading...
