Installation
A1-10
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
To Install an Electric Gun
Follow the instructions in the manual shipped with the gun to complete
the following procedures:
S Mount the gun on the production line.
S Install the gun driver.
S Connect power to the driver.
S Connect a triggering device to the driver.
S Connect a hose to the gun.
Instructions for connecting the hose and gun cordsets are given later in
this section. Refer to Connecting Gun and Hose Cordsets.
To Install a Hand-Operated Gun
Follow the instructions in the manual shipped with the gun to connect the
hose to the hand-operated gun. One end of the hose is wired to the gun;
the other end connects to the unit. Instructions for connecting the hose
and gun cordsets are given later in this section. Refer to Connecting Gun
and Hose Cordsets.
To Next Page
Loading...
