Nordson 3000V Series - Page 82

Installation
A1-80
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
Table A 1-28 Record of System Faults
Fault Code
(See Note A)
Day
Occurred
Action Taken Additional Notes
NOTE A: Fault Code 0 = No fault has occurred. Fault Code 5 = Control board is bad.
Fault Code 1 = Zone is below setpoint Fault Code 6 = Brownout has occurred.
temperature Fault Code 7 = Pattern control board is faulty.
Fault Code 2 = RTD is open Fault Code 8 = Gun circuitry is faulty.
Fault Code 3 = RTD is shorted. Fault Code 8 = Gun circuitry is faulty.
Fault Code 4 = Zone is Fault Code 9 = Control system cannot communicate
overtemperature. with pattern control.
R
eco
r
d
o
f
S
y
s
t
e
m
F
au
l
t
s