Installation
3-2
Part 1105120-03
E 2015 Nordson Corporation
S Leave at least six inches of ventilation clearance on all four sides of the
system controller.
S If the system controller is mounted in an enclosure, there must be free
and unobstructed ventilation from top to bottom and side to side within
the enclosure. Contact your Nordson representative for enclosure
cooling requirements.
753.00 [29.67]
790.50 [31.12]
257.00 [10.118]
453.50 [17.854]
25.40 [1.00]
703.00 [27.70]
25.25 [.99] 158.19 [6.23]
ø28.50 [ø1.12]
NORDSON CORPORATION
555 JACKSON STREET
AMHERST, OH 44001, USA
Voltage Frequency KVA
Part No.Model Serial No.
P
0
6
4
2
8
0
6
4
2
NET
RATE
2
5
1
P
REMOTE
LOCAL
MAGNETRON
AIR PRESSURE
SYSTEM OFF
SYSTEM ON
SET−SAVE
STANDBY
POWER
SETPOINT
SETTING
POWER
NETWORK
LAMP HEAD
MPS2−610
143.10
(5.64)
143.10
(5.64)
152 mm
(6 in.)
Required Ventilation Clearance
(All Four Sides)
Sized for
3/4 in. Conduit
Figure 3-1 System Controller Dimensions and Required Ventilation Clearance
To Next Page
Loading...