Nordson Coolwave 2610 - Power Load Balancing; System Connection Diagrams

Installation
3-4
Part 1105120-03
E 2015 Nordson Corporation
Power Connections (contd)
CW2-610 External Blower
T3 Control Transformer
High Voltage
T2
T1
480V
H4
400V
H3
380V
H2
0V
H1
CW2-610 Internal Blower
T3 Control Transformer
480V
H4
400V
H3
380V
H2
0V
H1
Figure 3-2 System Controller Transformers
Power Load Balancing
Refer to the System Connection Diagrams. If you are supplying power to
more than one system controller from a single source, shift the phases to
balance the load as shown in Figures 3-4 and 3-5. If you have more than
three system controllers, repeat the phase shift sequence again starting
with the fourth system controller.
System Connection Diagrams
Only the network configuration settings are shown in the following diagrams.
All other settings are optional and depend on the application. Refer to Table
3-6 for all configuration settings.
Unicable Connection: Refer to page 3-21.
RF Detector Installation: Refer to page 3-22.