EasyManua.ls Logo

Nordson Coolwave 2610 - System Controller Repair Parts

Nordson Coolwave 2610
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parts
7-2
Part 1105120-03
E 2015 Nordson Corporation
System Controller Repair Parts
See Figure 7-1.
Item Part Description Quantity Note
- - - - - - 50/60 HZ System Controller, CW2 1
1 1077135
S CONNECTOR, I/O board, CW2, kit
1
2 1077121
S TRANSFORMER, HV, CW2, kit
2
3 1089207
S TRANSFORMER, control, CW2, kit
1
4 772214
S FAN, 6 in x 1.5 in, 240 VAC
2 A
5 1098890
S MAIN CONTROL BOARD with contactor, CW2,
standard, kit
1 C
6 775142
S PCB, display, CW10, kit (display board)
1
7 1102449
S PHASE CONTROL BOARD AND CABLE,
CW2, kit
1
8 1077131
S I/O CONNECTOR BOARD, CW2,
with DeviceNet, kit
1 D
8 1083974
S I/O CONNECTOR BOARD, CW2,
without DeviceNet, kit
1 D
9 1091465
S FUSE, CW2, kit
1 A, B
9a −−−−−−
SS FUSE, 30 amp, slow-blow, 500V
3 B
9b −−−−−−
SS FUSE, 10 amp, time-delay, 250V
2 B
9c −−−−−−
SS FUSE, 160 ma, 250V, slow-blow, 5 x 20 mm
1 B
9d −−−−−−
SS FUSE, 2 amp, slow-blow, 250V, 5 x 20 mm
1 B
10 103200
S FUSE, 3 amp, slow-blow, 250 volt
2 A
11 1077128
S DIODE, HV, CW2. Kit (diode block)
2
12 −−−−−−
S SCREW, truss head, M5 x 8
6
13 772236
S SWITCH, control, MPS-410/610
1
14 1077129
S FUSE BLOCK, 3 pole, CW2, kit
1
15 1077130
S FUSE BLOCK, 2 pole, CW2, kit
1
16 1077127
S CONTACTOR, CW2, kit
1 C
17 −−−−−−
S CONTACTOR, 4 pole, 600V, 20A
1
18 1078306
S CAPACITOR, CW2, kit
1
19 1077134
S POWER COVER, CW2, kit
1
20 1077132
S BUMPER, CW2, kit
1
21 −−−−−−
S FILTER, 3 phase, line
1
22 1077125
S MEMBRANE, CW2, kit
1
23 1089206
S HARNESS, unicable, internal, kit
1
NS 1077126
S COVER, system controller, kit, CW2
1
24 1086731 DETECTOR, RF, kit, CW 1
NOTE A: Recommended spare part. Keep this part in inventory to avoid unplanned downtime.
B: Fuse kit 1091465 contains three 30 amp, 500 volt main fuses; two 10 amp, 250 volt fuses for the step
down transformer; one 160 microamp, 250 volt control board fuse; one 2 amp, 250 volt fuse for the
filament transformer.
C: This part is a 4 pole, 600V, 20A, 24V coil contactor.
D: Choose correct I/O board kit for your application.
NS: Not Shown

Table of Contents