Installation
3-13
Part 1105120-03
E 2015 Nordson Corporation
115
(4.53)
150
(5.906
115
(4.53)
53.3 (2.1 Focus)
78.8 (3.1 Focus)
199.2 (7.84)
266.4 (10.48)
370
(14.56)
∅150.0
(5.906)
435.9
(17.16)
150
(5.906)
Typ. 3 sides
M5 Screws
(Typ. 3 sides)
65.0 (2.559)
114.0
(4.488)
Top Pressure Port *
Bottom
Pressure
Port *
18.25 (0.719)
76.0 (2.992)
9.50 (0.374)
182.0
(7.165)
76.0 (2.992)
76.0 (2.992)
Unicable
Receptacle
* DO NOT BLOCK PRESSURE PORTS
WHEN MOUNTING LAMPHEADS
M4 Threaded Mounting Holes (8)
23.5
(0.925)
Inlet for 6-in. ID Duct
Bottom
Pressure
Port *
All measurements in mm (in.)
Figure 3-9 Lamphead Dimensions − External Blower Version
NOTE: Refer to page 3-18 for top and bottom pressure port usage. It is
important that the pressure port being used to measure differential pressure
not be blocked, and that the appropriate port be used depending on the
cooling air and exhaust air arrangements.
To Next Page
Loading...