Installation
3-14
Part 1032059B
E 2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
Operating Parameters
The melter uses operating parameters to store noneditable and editable
values. Noneditable values are those that provide information about the
historical performance of the melter. Editable values are either a numeric
set-point or a control option setting. Control options settings affect the
display of information or the function of the melter.
Operating parameters are stored in the melter’s firmware in the form of a
sequentially numbered list. The list is organized into the logical groups
described in Table 3-5.
Table 3-5 Parameter Groups
Group
Parameter
Numbers
Group Description
Standard 0 to 11
Noneditable and other frequently used
parameters
Temperature Control 20 to 26 Control heaters
Seven-day Clock 50 to 77 Configure the clock feature
In addition to the ability to read and edit parameter values, you can also
review a log of the last ten changes that were made to editable parameters.
Selecting Operating Parameters
Table 3-6 provides a complete list of the operating parameters.
Review the list to determine which operating parameters would best support
your manufacturing process. Refer to Appendix B, Operating Parameters,
for detailed information about each parameter. Appendix B contains a
complete description of each parameter, including its affect on the melter,
default value, and format.
NOTE: Parameters that are used to configure optional equipment or that
are otherwise reserved in the firmware are excluded from Table 3-6 and
Appendix B.
Reading or Editing Operating Parameters
Regardless of whether a parameter’s value is editable or not, the procedure
for accessing each parameter in order to read or edit its current value is the
same.
To Next Page
Loading...
Need help?
General
