Nordson FP-200 Instruction Sheet

Converting an FP-200 Extrusion Gun to an FP-200 Swirl Gun
12
Part 237494_02
E 2012 Nordson Corporation
Restoring the System to Normal Operation
Use this procedure to restore the applicator and converted gun to normal
operation.
1. Reconnect the gun to the suspension system by reconnecting the gun
and hose hydraulically and electrically, then reconnecting the gun to the
air supply.
2. Restore electrical power to the applicator.
3. Move the applicator circuit breaker to the ON position.
4. Let the unit and hose reach operating temperature.
5. Retighten gun-to-hose and gun-to-applicator fittings.
6. Check for low pressure leaks at the gun-to-hose fitting.
7. Turn the air supply on.
8. While slowly restoring air pressure to the gun to 379.2 kPa (55 psi), check
for leaks. Retighten fittings as necessary.
9. Resume normal operation.
Parts
To order parts, call the Nordson Customer Service Center at 800-241-8777
or contact your local Nordson representative. Use the following parts lists to
describe and locate parts correctly.

Nordson FP-200 Specifications

General

Brand	Nordson
Model	FP-200
Category	Paint Sprayer
Language	English