Nortrac 82XTC - Tightening Torque Table of Major Screws, Bolts and Nuts

Appendices
102
lifter, and front
drive axle
International
standard
General purpose oil (including steering oil) may be used, such as MF1135
of Massey Ferguson, M2C 86A of Ford and J20A of John Deere.
Can use MF1135 (Massey Ferguson), M2C 86A (Ford), or J20A (John Deere)
general-purpose oil. (Steering fluid reservoir included ).
Steering fluid
reservoir
Domestic
standard
L～HM32 wear-resistant hydraulic oil
Oil cup
Domestic
standard
GB/T 7324 compliant general-purpose lithium base grease for automobile
International
standard
Use NLGI D-217 grease with a viscosity grade of 2
Braking system
Domestic
standard
Triple-purpose hydraulic/transmission/brake oil. Implementing standard:
Q/LWZ B119
International
standard
SAE 10W oil with quality class compliant with API CD grade standard can
be used.
Windshield
Use for windshield washer. When air temperatures are under -10°C, use -45# antifreeze
washer fluid (SH/T0521).
Hybrid use of oils of different brands and manufacturers is strictly forbidden so as to avoid affecting
service performance of the machine.
On the tractors with heaters or air conditioning, antifreeze must be used in winter to avoid frost cracks
in this equipment and in the engine.
10.2 Tightening Torque Table of Major Screws, Bolts and Nuts
Table 10-2 Tightening Torque Table of Major Screws, Bolts and Nuts
Name and Assembly Location
Thread
Specification
Tightening
Torque (N·m)
Ft. /Lbs.
Bolt connecting engine with gearbox.nut
M10
60~70
44~52
Bolt connecting engine with gearbox.nut
M12
90~110
66~81
Bolt connecting engine with gearbox.nut
M14
150~180
111~133
Bolt connecting engine with gearbox.nut
M16×1.5
200~260
148~192
Bolt connecting gearbox with rear axle
M12
90~110
66~81
Bolt connecting gearbox with rear axle
M16×1.5
200~260
148~192
Engine and clutch housing
M8
25~30
18~22
Fixing bolt of the large bevel gear
M14×1.5
160~200
118~148