Nortrac 82XTC - Operation and Technical Maintenance

Maintenance Instructions
73
required to protect against coolant freezing.
3. At the start of every shift start the engine in accordance with winter starting procedures.
4. In order to protect the tractor and ensure that the engine is easy to start, it is recommended that the tractor
be parked in an insulated machine shed or garage during cold periods.
4.1.8 Technical Maintenance for Long-Term Storage
If the tractor is going to be kept in storage less than 1 month, and the time since the last oil change does
not exceed 100 hours of running time, special technical maintenance is not required. If the tractor is going to
be kept in storage longer than 1 month, special technical maintenance should be performed according to
Section 5 – Storage as specified in this manual.
NOTE : After performing tractor maintenance and all cleaning and repair is completed, all the guard
covers and plates should be reassembled. Otherwise, it can cause a potential safety hazard. All waste oil should
be collected in a suitable container and disposed of properly.
4.2 Operations for Technical Maintenance
4.2.1 Tractor Maintenance
Table 4-1 82XTC Series Tractor Maintenance
Item
Maintenance/Repair Position
Operation Content
No. of
Points
Maintenance Time
(hour)
Remark
1
Engine water pump shaft
Fill lube grease
1
2
Engine oil pan
Check oil level
1
3
Engine air filter
Check and clean
1
Every shift
4
Clutch/brake pedal axle
Check oil level
2
Every shift
Fill if
necessary
5
Steering wheel thrust bearing
Check oil level
2
Every shift
6
Rear wheel hub
Check oil level
2
Every shift
7
Right/left lifter rod
Check oil level
2
Every shift
8
Steering track rod ball pin
Check oil level
2
Every shift
9
Front axle swing for four -wheel
drive
Check oil level
2
Every shift
10
Steering oil cylinder
Check oil level
2
Every shift
11
Battery
Check oil level
1
Every shift
12
Hydraulic steering oil tank
Check oil level
1
Every shift
Fill if
necessary
13
Radiator
Check coolant
level
1
Every shift
Add if
necessary
14
Lifter
Check oil level
1
Every shift
Fill if
necessary
15
Gear box-rear axle
Check oil level
1
Every shift
Fill if
necessary
16
Fan V-belt
Check tension
1
50
17
Engine oil pan
Change lube oil
1
200