4. When removed from the tractor for any reason, the battery should be stored in a clean, dry and
well-ventilated area with a temperature that is 32–104F. The battery should be handled with care and
stored right side up.
5. The power supply should be tightly connected to the battery terminals, in order to prevent the terminal from
melting when the tractor is started. In order to avoid terminal oxidation or corrosive, the exterior of
terminal should be coated with petroleum jelly or corrosion preventative spray.
6. Keep the exterior terminals of the battery clean.
7. Check the voltage regularly to make sure that the regulator is working properly. The voltage for the
regulator is 14.2.1±0.2V.
Check the generator output voltage regularly. The voltage should be 14.2±0.25V.
NOTE:
1. When charging the battery, keep it in a ventilated area and far from open flames. When charging is over,
shut off the power in order to avoid a fire or explosion.
The position of combined headlights is shown in Figure 4-14.
Figure 4-14 Combined Front Head Lamp Position
The position of the rear lamp and tail lamp assembly (steering, position
and braking) is shown in Figure 4-15.
Figure 4-15 Taillight Assembly and Position
To Next Page
Loading...
