78 AFP-200 Instruction PN 15511:F2 10/11/99
Notifier 911AC – for connection to a Central Station Receiver or Protected Premises Receiving Unit. This unit
must be installed as shown in Figure B-1. For additional information on the 911AC, refer to Document
74-06200-005. Because the 911AC does not mount in the control panel backbox, all connections must be in
conduit, less than 20 ft. in length in the same room.
Notes:
1. Set SW3 on the control panel circuit board to 'TBL LESS AC' (downward) position. This delays the
reporting of an AC fail condition for approximately 8 hours, to comply with the 1993 UL standards. SW3 is
located on the right center of the main circuit board.
2. All input and output connections are inherently low voltage and power-limited. Use UL-listed, power-
limited cable only.
002-PFA002-PFA
002-PFA
002-PFA002-PFACA119CA119
CA119
CA119CA119
mralAmralA
mralA
mralAmralA
stcatnocnepoyllamron
3.mreT3BT7dna6
5.mreT3BT9dna8
elbuorTelbuorT
elbuorT
elbuorTelbuorT
stcatnocnepoyllamron
6.mreT3BT01
8.mreT3BT11
yrosivrepuSyrosivrepuS
yrosivrepuS
yrosivrepuSyrosivrepuS
stcatnocnepoyllamron
1.mreT3BT21
2.mreT3BT11
Figure B-1 NFPA 72-1993 Signaling Systems for Central Station Service (Protected Premises Unit)
and Remote Station Protective Service
To Central Station
NotiFire 911AC
Digital Communicator
AFP-200
To Next Page
Loading...
