Security Alarm Event Operation of the Control Panel
NFS-3030 Operating P/N 51344:C 11/4/03 31
action. ( Refer to Figure 1.7 on page 16 for an example of the this screen and an explanation of
its fields.)
3. Correct the condition that activated the Security point.
4. When the Security condition is corrected, press the SYSTEM RESET soft key to return the
control panel to normal operation (indicated by the “System Normal” message). The control
panel sends a “System Normal” message to the panel display, History buffer, installed printers
and annunciators.
The soft key PROGRAM/ALTER STATUS is also displayed on this screen. A password is required
to enter these menus, which are described in the NFS-3030 Programming manual.
2.3.4 Interpreting Security Type Codes
The Type ID code that displays in a security alarm message is related to the type and function of the
point that initiates the security alarm. For example, a monitor module with a TAMPER Type ID
code means that the monitor module connects to a tamper switch. If the Type ID code is unfamiliar,
refer to "Software Type ID Codes" on page 59. This appendix is an alphabetical list of Type ID
codes and an explanation of each.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
