9
Use of Tools
Platform: The model is adhered to the platform during the printing process.
Resin Vat: A container for resin material.
Power Cable: Connect to the power supply.
Funnel: A tool for recycling resin materials.
Filter : Filter the cured remains in the used resin.
Gloves: Protect hands from injury.
USB Flash Drive: Contains NovaMaker software User Manual, e-manual, model file, etc.
Spatula: Use to check if there are residues of cured resin in the vat before each printing
process.
Pliers: Use to cut off the model support.
Spray Bottle: Spray alcohol to clean the residual resin on the model.
Spare Screws: Spare screws for securing FEP film, LCD screen and device base.
Hex Wrench: The disassembling tool for maintenance and replacement of parts.
FEP Film: A film installed at the bottom of the vat to separate the model.
Quick User Guide: Help you to get started quickly.
To Next Page
Loading...