深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
42
b. Starting
Remove the UV cover, fill the vat with resin, then install the UV cover back on the printer.
1. Transfer the file from NovaMaker to the printer (via Wi-Fi /Ethernet or using the USB drive)
and start the printing process. Transfer files from NovaMaker to the printer via WIFI or
Ethernet. Enter the device management interface and click to open the file, select the
sliced .CWS file in the computer, it will be displayed in the list after uploading, select the file
just uploaded and choose to start printing
To Next Page
Loading...