NOVA3D ELFIN - Connecting the Printer to a Network

17
6. Connecting the Printer to a Network
Nova3D ELFIN can be connected to a local network in two ways: via Wi-Fi or an Ethernet
cable. Both methods allow you to manage the printer directly from NovaMaker and make it
possible to remotely transfer .cws files from your computer to the printer.
To connect the printer with an Ethernet cable:
Plug the cable to the port of the device and plug the other end of the cable to the network
interface of the computer or network adapter . Open NovaMaker software, click the icon on the
right side of the title bar to enter the printer management interface, then click the "+" on
the upper right side to display the pop-up box of "printer add guidelines", select the first item
(the printer has not done network configuration...) and then proceed until prompted to add the
printer successfully.