3
of any product; (Ⅱ) the responsibility for including but not limited to specific, joint or collateral
damage; And (Ⅲ) Nova3D doesn't do any implied warranty, including not guarantee of the
applicability, non-infringement and merchantability of the specific use.
No license, express or implied, by estoppel or otherwise, to any intellectual property
rights is granted by this document or any act of Nova3D. Trade names, logos and trademarks
mentioned herein may be trademarks or trade names of their respective owners.
General Safety Information
This User Manual contains important safety directions that should be followed during
installation and operation of the Nova3D ELFIN. It also mentions situations which require
special attention and includes warnings against negligence and misuse that could cause damage
or injuries.
Always read the safety data sheets available at:
http://www.nova3dprinter.com/material.html. There are a source of basic information and
safety procedures for the materials you bought. It is essential to regularly update the firmware
to avoid any kind of failures.
Visit our website: http://www.nova3dprinter.com/ to learn about the latest news and
updates.
Printing process with the Nova3D ELFIN requires using liquid photosensitive resin which
in a liquid form is low toxic and may cause allergic reactions. Therefore, you must protect your
skin and eyes when using the printer by wearing safety gloves and glasses. Proper ventilation is
required in the print room.
It is also extremely important to avoid spilling the resin on the printer and its surroundings
while operating the printer, filling the vat and removing prints from the platform. Ensure that
the printer is level and keep it on a stable surface. Do not remove the UV cover during the
printing process.
To Next Page
Loading...