102 103
Appendix
Firmware Updates
In order to access all features, you may need to update Circuit Tracks to the latest firmware
version. Components will let you know whether the connected unit is up to date and, if it’s not,
Components can update the unit’s firmware to the latest version.
Setup View
Setup View is provided to allow “global” unit settings to be made: these include MIDI channel
assignment, MIDI I/O configuration, clock source selection, external clock rate, master compressor on/
off and brightness adjustment. It is entered by holding down Shift and pressing Save, and exited by
pressing Play
13
.
Opening Setup View produces the display shown below:
9
5
11 1312 14 15 16
2 ppqn
Tx
On/Off
3 7
10
64 8
Rx
On/Off
1 ppqn
Rx
On/Off
Tx
On/Off
Rx
On/Off
Tx
On/Off
Rx
On/Off
Tx
On/Off
1 2
4 ppqn 8 ppqn 24 ppqn
MIDI Note data
MIDI Program
Change data
MIDI CC data
MIDI Clock control
Brightness
adjustment
Synth 1 Drum 4Drum 3Drum 2Drum 1Synth 2 MIDI 1 MIDI 2
MIDI channels 1 -16
Default MIDI
channel for Synth 1
is Channel 1
MIDI Channel
16 is reserved
for the Project
MIDI data control
Clock sync rates
Default external
clock sync rate
is 2 ppqn
Synth 1 is currently selected: the pads
for the unassigned MIDI channels
illuminate in the track colour
MIDI 1 and MIDI 2 are set to
use their default MIDI
channels - 3 and 4
respectively
Default MIDI
channel for Synth 2
is Channel 2
Default MIDI
channel for
Drums 1-4 is
Channel 10
To Next Page
Loading...