22 23
Loading and Saving
When you press Play for the first time after powering on, the Project which Circuit Tracks
plays will be the last one used when it was powered off. The factory demo described in the
previous section was loaded in to Memory Slot 1.
To load a different Project, you use Projects View. Press Projects
19
to open this:
There are 64 memory slots, arranged as two pages of 32. Use the J and K buttons to scroll
between the pages. Each pad corresponds to one of the memory slots. The pad’s colour indicates
the slot’s status:
• White – the currently selected Project (only one pad will be white)
• Bright blue – slot contains either a Project saved by the user* or a factory demo Project
• Dim blue – slot is empty
* But see paragraph on “Changing Project Colours” on page 97.
If you’re still experimenting, you can select a different factory demo to listen to and play around
with. You can jump between saved Projects while in Play mode: the current Project will complete
its current Pattern before the new Project starts. (If you hold down Shift while selecting a different
Project, it will commence to play immediately.)
Projects loaded when the sequencer is not running will play at the tempo that was in force
when the Project was saved.
Projects loaded while the sequencer is running will play at the tempo that is currently set.
This means that you can recall different Projects sequentially with the confidence that the tempo will
remain constant.
To Next Page
Loading...