104
Brightness
Pad 24 (illuminated white) controls the brightness of the grid pads. The default setting is for full
brightness, but pressing Pad 24 dims them by approximately 50%. This can be of benefit if you are
running Circuit Tracks on its internal battery. You may also wish to run with reduced brightness if
performing in conditions of low ambient lighting.
The brightness setting is saved when Circuit Tracks is powered down.
MIDI Channels
The factory default MIDI channels are as follows:
Track MIDI channel
Synth 1 1
Synth 2 2
MIDI 1 3
MIDI 2 4
Drums 1 – 4 10
You can change the MIDI channel which each track uses in Setup View. Each track - Synth 1, Synth 2,
MIDI 1, MIDI 2 and Drum 1 - 4 can be set to any of MIDI channels 1-15. Channel 16 is reserved for the
Project. Note that all four drum tracks use the same MIDI channel.
To change the MIDI channel that will be used by either of the synths or by the drums, press Synth 1, Synth
2, MIDI 1, MIDI 2 or any of the Drum tracks pads
5
to select the required track. The top two rows of
pads in Setup View represent the MIDI channels 1-16. Press the pad for the required MIDI channel.
Important: No two tracks can transmit on the same MIDI channel.
The graphic on page 103 illustrates the display when Synth 1 is selected: the colours of the pads for
the unused MIDI channels differ for Synth 2, the MIDI tracks or Drums. The bright violet, pale green,
blue, pink and orange pads indicate the MIDI channel to which each track is currently assigned.
As with all Setup View changes, press Play to save your changes and exit Setup View.
To Next Page
Loading...