98 99
Loading a Pack
First select a Pack by pressing any lit pad other than that for the currently loaded Pack. It will start
pulsing between dim and bright (in its assigned colour) to confirm that it is “primed” and can now be
loaded. It is not possible to load an “empty Pack slot”, as it will not contain any synth patches, MIDI
templates or drum samples. It is also not possible to reload the current pack.
[If you do not wish to load a primed Pack, either prime a different Pack for loading or exit Packs View.
When you return to Packs View, no Pack will display as primed.]
Once a Pack is primed, press the play button to load the Pack. An animation will play on the pads for
a few seconds while the Pack loads, and once the load is complete Packs View will be displayed again
with the pad for newly loaded pack lit white.
Duplicating Packs
If you run out of Projects in a Pack, but would like to continue working on new Projects with the same
set of synth patches and samples, you may duplicate the current pack.
To duplicate the current pack, first enter Packs View. Hold Duplicate
18
and the currently selected
Pack will pulse green, while the available Pack slots will be lit dim blue. Press a dim blue slot to write
the current pack to the new location.
Note that Packs may only be removed via Components, and cannot be cleared from the device
directly.
To Next Page
Loading...