88
adjusting tempo and swing alternately, you may notice a short delay before the knob adjustment takes
effect. This is to allow you to check the current Tempo and Swing values without altering them.
Swing can be used to add an extra “groove” to your pattern. Note that as it is the even steps that are
“swung”, these can be interpreted as 1/16-notes (semiquavers).
Click track
The Click (or metronome) can be activated or deactivated by holding Shift and pressing Clear
17
.
Clear will light bright green when Click is enabled and dim red when it is not. When enabled, you will
hear a metronome tick at every quarter note on all audio outputs whenever the sequencer is playing.
This is a global setting therefore Click will remain on or off regardless of Pack or Project changes. The
setting is not saved when Circuit Tracks is powered off.
To adjust the volume of the Click, press Tempo/Swing and use Macro 5 (the one above the Clear/
Click button). Click level is also a global setting therefore applies to all Packs and Projects. The level
setting is saved when the device is powered off using the power button
8
.
Analogue Sync Out
It is very easy to synchronise external equipment – e.g., analogue synths – to Circuit Tracks with the
rear panel Sync Out connector
2
. This provides a sync pulse at a rate proportional to the tempo
clock (BPM); the actual ratio can be set in Setup View – see page 103. The default rate is two pulses
per quarter note.
To Next Page
Loading...