88 89
Mixer
Circuit Tracks includes an eight-channel mixer to let you adjust the volume of each track relative
to the others. By default, all the tracks play at a volume level of 100 (arbitrary units, range 0-127),
leaving you with the Master Volume control
4
to adjust the output level as required.
Press Mixer
11
to open Mixer View:
Synth 1 Drum 4Drum 3Drum 2Drum 1Synth 2 MIDI 1 MIDI 2
Scene pads
J
ProjectsSaveDuplicateClear
Tempo
Swing
Tap Click Mutate Packs
2 Oscillator Mod
1 Oscillator 3 Amp Envelope
4 Filter Envelope
5 Filter Frequency
6 Resonance
7 Modulation
8 FX
MUTE
SYNTH 1
MUTE
SYNTH 2
MUTE
MIDI/AUDIO
IN 1
MUTE
MIDI/AUDIO
IN 2
MUTE
DRUM 1
MUTE
DRUM 2
MUTE
DRUM 3
MUTE
DRUM 4
(Pulsing
bright/dim)
The illuminated pads on Row 1 are Mute buttons for each track. Press a pad to stop the sequencer
triggering the synth track notes, drum track hits, MIDI track notes outputs and CC automation, which in
turn will mute the track; press again to unmute. The pad’s illumination dims to indicate a Mute state.
Input Level control
By default, in Mixer View the Macros control volume level of each track. This is indicated by the J button
15
being lit. Macro LEDs light in the corresponding track colour, and dim as the track level is reduced.
Macro controls 3 and 4 (the MIDI tracks) control the level of external analogue audio sources
connected to the rear panel Inputs 1 and 2
5
. These can be used to add the outputs of external
To Next Page
Loading...