Set the Tempo
In Note Repeat settings mode, repeatedly press the key labelled Tap Tempo until you’ve set the desired
tempo. With Master Sync enabled in FL Studio (this is by default), the screen reads ‘Tempo External’–
tap tempo is changing the DAW tempo. The Note Repeat button will flash at the tempo you set.
Change the note/drum hit velocity
You can use pad pressure to control the Note Repeat hit’s velocity. The initial velocity is set as you
press the pad. As you hold it, you can increase pressure to increase velocity, or reduce pressure to
reduce velocity, etc.
If you reduce pressure after the initial hit, the Note Repeat output keeps the initial velocity constant and
only change velocity if you increase the pressure above the initial velocity setting.
Pot Pickup
When you connect FLkey to FL Studio, it follows the Pickup (takeover mode) setting in FL Studio’s
Settings.
In standalone mode, you can turn on Pot Pickup from the settings menu. When Pot Pickup is on,
FLkey saves the various pages for the Pot’s states. The control only outputs MIDI when it moves to the
position of the saved state. This prevents sudden jumps in the control’s value.
When you move a pot, and it’s not yet picked up the value, the screen displays the saved value until
you’ve moved it to the pick-up point.
FLkey User Guide
43
To Next Page
Loading...
